Chemical Injection

Chemical injection is the process designed to assist in the production of oil. Various chemicals are injected into the crude oil to provide a degree of protection.  For example a scale inhibitor will prevent the build-up of scale on the pipes and fittings used to transport the oil on its journey to the refinery.  Flowmeters are used to monitor and control the amount of chemicals added to the crude oil.  Biocide prevents the build-up of organisms in the pipe.  Corrosion inhibitor is the most popular additive to be measured.  There are various types depending on the type of main liquid. Pour point depressant is added to reduce the pour point thereby making the oil easier to flow through the main pipelines.  Most of the chemicals added tend to be at low flow rates of the order of 0.01 to 40 litres per hour.  LDH or Low Dosage Hydrate Inhibitor has the highest injection rate sometimes up to 17,000 litres per hour.  It is designed to inhibit water based mixtures which would otherwise have a tendency to freeze.  Methanol is often used with the same effect.  More exotic chemicals are used for similar purposes all with the intention of reducing cost on the way to the refinery.  It is a less known fact that flowmeters are used to measure these chemicals which contribute 30% of the cost of running an offshore platform.  Control systems are often manually set from the flowmeter displayed value (either locally or from the SCADA system) and there is a trend towards automation of this process using control valves.  A typical turndown ratio of 500:1 is measurable with some Positive Displacement flowmeters.  Often the systems are relatively slow dynamically and need only slight adjustments from day-to-day which are why manual control is still popular.  It is important that the flow measurement system for the chemicals is able to cope with the pulsing nature of the pumps used and also with the high pressures that are encountered.  These can be up to 1380bar/20,000psi/20ksi in modern systems injecting subsea.  Topsides injection is at lower pressures typically from 200 to 1000 psi.  There is also a trend towards measuring the chemicals subsea i.e. underwater rather than when the crude oil reaches the surface.  Not only does the flowmeter have to work at high internal pressures of over 10,000 psi, 690bar but also with external pressures up to 345bar/5,000psi. Link to Brochure/pdf. Listed below are all the flow meters within our range that are suitable for chemical injection:


VFF Rotary Piston Positive displacement flowmeters, also known as PD meters, measure volumes of fluid flowing through by counting repeatedly the filling and discharging of known fixed volumes. A typical positive displacement flowmeter comprises a chamber that obstructs the flow. Inside the chamber, a rotating/reciprocating mechanical unit is placed to create fixed-volume discrete parcels from the passing fluid.
Turbine Inline "axial" turbine flowmeters are velocity measuring devices - they measure the average velocity of a fluid flowing through the body of the meter. Mounted within the body of a liquid turbine flowmeter is a vaned rotor. The rotor is centred on a shaft and allowed to rotate on bearings. The shaft is supported in the housing by tube bundles that also provide a measure of flow conditioning for the fluid stream.
Helical Screw Positive displacement flowmeters, also known as PD meters, measure volumes of fluid flowing through by counting repeatedly the filling and discharging of known fixed volumes. A typical positive displacement flowmeter comprises a chamber that obstructs the flow. Inside the chamber, a rotating/reciprocating mechanical unit is placed to create fixed-volume discrete parcels from the passing fluid.